Download ArtCAM Pro Tutorials PDF

TitleArtCAM Pro Tutorials
LanguageEnglish
File Size8.3 MB
Total Pages298
Document Text Contents
Page 2

Disclaimer
Delcam plc has no control over the use made of the
software described in this manual and cannot accept
responsibility for any loss or damage howsoever caused
as a result of using the software. Users are advised that all
the results from the software should be checked by a
competent person, in accordance with good quality
control procedures.
Information contained in this manual is subject to change
without notice and does not represent a commitment by
Delcam plc. The software described in this manual is
furnished under licence agreement and may be used or
copied in accordance with the terms of such licence. No
part of this manual may be reproduced or transmitted in
any form or by any means, electronic or mechanical,
including photocopying and recording, for any purpose
without the express permission of Delcam plc.

Copyright © 2004 Delcam plc. All rights reserved.
Delcam plc
Talbot Way
Small Heath Business Park
Birmingham B10 OHJ
England
Tel: (UK) 0121-766-5544

(Int) +44 (0) 121-766-5544

Page 298

290 • Tutorial – Bridging ArtCAM Pro Tutorials

3. Click and drag in the 3D View window to create a
bounding box around one of the bridges. You can now see
the bridge on the Profile toolpath clearly:

You are now ready to simulate and save the toolpath. For further
information, see "Simulating Toolpaths" and "Saving a Toolpath" in
the Machining Models chapter of the Reference Manual.

Similer Documents